SimBiology

팔로우

SimBiology Model Analyzer の Fit Data タスクを実行すると、 Integration Tolerance Not Met のエラーが発生します。回避方法を教えてください。 kA031000000TCuvCAG 000068315

I am running a Fit Data task in Simbiology for a two step model: L + A <---> LA LA + BG <---> C The reaction rate for the two reactions are respectively: kon1*A*L - koff1*LA kon2*LA*BG - koff2*C I am using the concentration of C as my independent / response variable and time as my dependent / predictor variable to estimate the parameter "kon2"; the other three parameters are known. Every time I run the simulation, I get the following error: Integration Tolerance Not Met I have tried changing i) the initial value of "kon2", ii) the tolerance and number of iterations, and iii) the solver used to estimate the parameter, to no avail. What could be causing this error and how can I resolve this? kA031000000TCuvCAG 000068315

I followed the video https://www.mathworks.com/videos/building-a-model-in-simbiology-68960.html?s_tid=srchtitle_drag%20a%20line%20to%20create%20reaction_1 to create a model. But I cannot drag a line between two species to create a reaction. What did I miss?

When I am writting a rate rule I am getting this above error message. My rule is LuxI = (1/Tx) ∗ (((tl_luxI ∗ [mRNA_luxI]) ∗ Tx) − ((dLuxI ∗ [LuxI]) ∗ Tx)) I have seen some of the error messages answers of Matlab but nothing worked in my case.Kindly help me with this.

While encoding a simple model of cell proliferation/death with rates r*X and d*X, which should result in an ODE such as dX/dt = r*X – d*X, I realised that it very much depends how the related 'Reaction' is formulated. With the correct stoichiometry 'B -> 2 B' all is fine but with 'B -> B' the growth flux is omitted entirely from the ODE. This is of course correct but it should come with a warning. I can imagin for complex model one is unable to verify whether the model is correctly interpreted and encoded. In this case the according reaction is visible in the diagram but the flux is not part of the relevant ODE. The question is: what are the other, if any, checks SimBiology performs behind the scenes which might result in differences between the model network and the model formulation?

Hi everyone, this feels like it should be easy, but I can't figure it out. I have a simple reaction A-->B following a given custom reaction rate. I want to add a delay. Using the event trigger I tried two approaches: # time<1800 B=0 # time<1800 Imax=0 (Imax is the reaction rate) However, in both cases the reaction is evaluated as if nothing ever changed. Any suggestions? What am I missing? (for completeness, in the actual model there are upstream components that funnel into A) Thanks a lot! Cheers, Michael