A question about FOC current control for PMSM

조회 수: 1(최근 30일)
haonan He
haonan He 2021년 3월 9일
댓글: haonan He 2021년 3월 10일
Hi,
I am trying to use Simscape to block a FOC current controller for PMSM motor. I set the reference Iq current to be 100 A and Id current to be -20 A. Although the Iq current can follow the expected value, the Id current keeps decreasing after suddenly reaches -20 A (see the figure). All the model parameters are the same as the MATLAB tutorial about PMSM (https://www.youtube.com/watch?v=lP4jbmthiyc&t=930s). The model in this vedio can have a good current control, but my model cannot (even though all the parameters are the same).
I appreciate it very much if you could help me out.
Haonan

채택된 답변

Pat Gipper
Pat Gipper 2021년 3월 10일
The decoupling control is not quite correct for the PMSM motor you are using. You need to insert a multiplier by the number of pole-pairs on the speed. See the picture below.
  댓글 수: 1
haonan He
haonan He 2021년 3월 10일
It works, thanks very much

댓글을 달려면 로그인하십시오.

추가 답변(0개)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by