How to plot again Figure when it is closed?

Hi all,

when I simulate a program, I plot 2 figures are Figure(1) and Figure(2).

I closed Figure(1) and run to simulate again. But Figure(1) does not appear. Why?

Please help me to solve them.

Thanks!

[David Hill]

I don't know if I understand your question, but turning the figure visiablity off and on might solve your problem. The matlab documentation is quite good and you should read about figures.

[darova]

didn't know about that option. thanks

[Ngo Sy]

David Hill. It means that. when I simulate a program. It plots Figure(1), Figure(2). I close (x) Figure(1), minimize (_) Figure(2), and run to simulate this program again. But Figure(1) does not appear, Figure(2) is the same.

BUT, if I choose Figure() to simulate, The value of Figure(1) will appear with Figure(3). I do not understand.

Please help me!

[Walter Roberson]

After you x figure 1, check

findall(0,'type', 'figure')

and see if you get back one or two figures