# Full vehicle model help

조회 수: 3 (최근 30일)
SilverSurfer 2016년 5월 3일
답변: Steve Miller 2023년 5월 9일
I'm trying to model a full vehicle with 8 dof:
• surge
• sway
• yaw
• roll
• rotation of wheels
I'm using a SAE coordinate system:
• x forward
• y to the right of the driver
• z down
I use Pacejka's formula for the calculation of longitudinal and lateral forces. These are the basics equations:
As regards notation
• AS is front left
• AD is front right
• PS is rear left
• PD is rear right
Can anyone help me to find out if I made modeling errors and to tune the model?
It seems to me the main problem is longitudinal slip. I do not understand which convention should I use. Inside Pacejka's book I found this:
I also found different formulas for driving condition where at denominator there is r*omega.
I find strange behaviours in the model, for example if I try to plot longitudinal rear force vs longitudinal slip. If I make a simulation without steering I get non zero values for roll angle, yaw rate, lateral velocity.
Now I'm using a step size of 0.001. Before I was using 0.01 and the graphics look like they came from experimental data.

댓글을 달려면 로그인하십시오.

### 답변 (1개)

Steve Miller 2023년 5월 9일

댓글을 달려면 로그인하십시오.

### 카테고리

Help CenterFile Exchange에서 Simulink 3D Animation에 대해 자세히 알아보기

### Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by