모델 설정
Simulink 모델을 명령줄에서 조정하려면 slTuner
인터페이스를 사용하여 모델을 조정할 수 있도록 구성하고, 조정할 블록을 지정하고, 분석점을 지정하십시오. slTuner
인터페이스는 Simulink 모델의 선형 근사 및 시스템 조정에 필요한 기타 정보를 저장합니다. 예제는 Create and Configure slTuner Interface to Simulink Model 항목을 참조하십시오.
함수
도움말 항목
- Mark Signals of Interest for Control System Analysis and Design
Analysis points allow you to access to internal signals, perform open-loop analysis, or specify requirements for controller tuning in systems modeled in either MATLAB® or Simulink.
- How Tuned Simulink Blocks Are Parameterized
Both Control System Tuner and the
slTuner
interface automatically assign predefined parameterizations to certain Simulink blocks. - Create and Configure slTuner Interface to Simulink Model
Use
slTuner
to create an interface to a Simulink model for command-line control system tuning and analysis. - Tune Control Systems in Simulink
At the command line, use
systune
orlooptune
to automatically tune control systems modeled in Simulink. - Approximate Nonlinear Behavior Using Array of LTI Systems
You can use linear parameter varying models to approximate the dynamics of nonlinear systems.