Feeds
질문
Running sequential simulations in a simulink model
I have a simulink model with a set of about 10 parameters. I also have a set of about 15 different sets of parameters, I am tryi...
13년 초과 전 | 답변 수: 1 | 2
1
답변답변 있음
Output first zero of a signal?
Thanks for that help, I have another related question though how would I go about finding the time difference between each succe...
Output first zero of a signal?
Thanks for that help, I have another related question though how would I go about finding the time difference between each succe...
13년 초과 전 | 0
질문
Output first zero of a signal?
Is there anyway to output the first time at which a signal is zero (excluding at t = 0)?
13년 초과 전 | 답변 수: 3 | 0
3
답변질문
How to I output the maximum value of a signal to a display?
Is there anyway to output the maximum value of a signal that varies with time in simulink to a display block?
13년 초과 전 | 답변 수: 1 | 0
1
답변질문
How to route a signal without routing it through every layer in a simulink model
Is there anyway to route or find the value of a signal that is in a reference model several subsystems below the outer level dir...
13년 초과 전 | 답변 수: 1 | 0
1
답변질문
Extracting a response time in simulink
So I have a control system in simulink which I have put into a test harness and I want to find the response time for that system...
13년 초과 전 | 답변 수: 1 | 0
1
답변질문
Error: Cannot propogate bus signal from output 1 to input 5
I keep getting this error when I try to run a simulation with a model reference. The signal is created by a subsystem which then...
13년 초과 전 | 답변 수: 1 | 1
1
답변질문
Nested buses in base workspace
I'm trying to define a nested bus structure in the base workspace of MatLab. However, I'm not sure how I should actually write t...
13년 초과 전 | 답변 수: 1 | 1
1
답변질문
Test harnesses and reference models
Hi, I am making a test harness in simulink to test an actuator model and have ran into a problem. The actuator itself is a re...
13년 초과 전 | 답변 수: 1 | 0
