Community Profile

photo

Kranti Balaga

Last seen: 1일 전 |  2021년부터 활동

Followers: 0   Following: 0

통계

  • Knowledgeable Level 2
  • Revival Level 2
  • First Answer

배지 보기

Feeds

보기 기준

답변 있음
ccsdsRSEncode , CCSDS RS Encoder input problem
Hi, The ccsdsRSEncode function and CCSDS RS Encoder Simulink block handles the interleaving based on the user's selection of I...

대략 2개월 전 | 0

답변 있음
how to perform frequency shift or frequency correction in simulation using HDL NCO and LOOKUP table(LUT) in order to generate HDL code
Your logic can be replicated with the help of the NCO HDL followed by mulitplier. Similar application, we used to correct the fr...

10개월 전 | 0

| 수락됨

답변 있음
Is it possible to extend the bus width from 32bit(16 for I,16 for Q) to 64bit(32 for I, 32 for Q) in HDL QAM Transmitter and Receiver?
We dont have an option to do automatically by configuring a parameter. You can start changing the symbol modulator and pulse sha...

1년 초과 전 | 0

| 수락됨

답변 있음
HDL QPSK Transmitter and Receiver CFO problem
Yes, simply you can provide the Symbol rate in the Inputdata mask, change the Carrier Frequency Offset (in Hz) corresponding to...

거의 2년 전 | 0

답변 있음
HDL QPSK Transmitter and Receiver CFO problem
Hi Ali Shan, I am fine, hope you are doing well. The more average length gives a better/accurate estimate, but that d...

거의 2년 전 | 0

답변 있음
HDL QPSK Transmitter and Receiver CFO problem
Hi Ali Shan, The value 0.125 implied in the algorithm that we choose. Implemented correlation based estimation, as the r...

거의 2년 전 | 0

답변 있음
HDL QPSK Transmitter and Receiver CFO problem
Hi Ali Shan, In QPSK single carrier model, the carrier frequency estimates in steps of coarse and fine estimates which a...

거의 2년 전 | 0

| 수락됨

답변 있음
Modifying the QPSK RX for TDD for hw/sw design in ad9361
Hi Muhammad, The Model you are referring is not supported for discrete valid of inputs, and the receiver is expecting alw...

2년 초과 전 | 0

답변 있음
HDL optimized QPSK TX and RX combined
Hi, There are some limitations in the model due to receiver architecture. Here, Timing recovery would be self synchronizin...

거의 3년 전 | 0

답변 있음
Addition of signals in simulink
Hi, To demodulate the I and Q signals without using QPSK demodulator block can be done for the hard decision. You can get I...

거의 3년 전 | 0