MATLAB Answers

How to deploy the interface model to SD card of Xilinx Zynq ZCU102 kit so that it will run everytime I power up my hardware ?

조회 수: 6(최근 30일)
丹 姚
丹 姚 2021년 7월 30일
답변: JT Ferrara 2021년 8월 2일
I uses Matlab 2020b and Xilinx Zynq UltraScale+ MPSoC ZCU102 evaluation kit for model based development.
I followed the example "Getting Started with Targeting Zynq UltraScale+ MPSoC Platform".
But when doing the step "Run the software interface model on Zynq ZCU102 hardware", I found that the deployed software will not effective anymore after the hardware power off and on again. "Monitor & Tune" or "Bulid, deploy &start" buttons has no difference on this power off and on case.
So how can I do to make the ARM executable still be effective and run automatically after hardware power off and on?

추가 답변(0개)

태그

제품


릴리스

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by