Error when using spice model for MOSFET for Basic Buck w/ PI control
조회 수: 5 (최근 30일)
이전 댓글 표시
Hi all. I'm trying to simulink a buck converter w/ PI control with a MOSFET SPICE model with a generated block created from a spice netlist. I keep getting thrown a error that I don't really understand. Below is the picture of my model and the error.
This is just a basic buck converter with PI control, so the only thing I was thinking was the problem was the MOSFET, but it keeps highlighting the simulink-ps converter as the issue which I don't really understand.
I have attached my files as well for feedback. If someone could explain what is going on, that would be super helpful. Thank you.
For reference: Node 3 is the source, Node 2 is the gate, and Node 1 is the Drain.
댓글 수: 0
채택된 답변
Yoshi Minagawa
2021년 7월 28일
Hi Christine,
When this error occurs, it maybe is valid to enable the filter of Simulink-PS Converter block. By enabling the filter, you can provide the derivatives needed for Simscape calculations. For details, please refer to the similar answer.
I hope this will help.
댓글 수: 0
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Semiconductors and Converters에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!