Unable to perform assignment because the size of the left side is 1-by-201 and the size of the right side is 200-by-1

조회 수: 1 (최근 30일)
Hello, I would like to change my prePeak and posPeak value from 0.0005 to 1/fs(which is the sampling frequency 24414)*100. However when I change the prePeak and posPeak value to 1/fs*100, I get the error message "Unable to perform assignment because the size of the left side is 1-by-201 and the size of the right side is 200-by-1". Any suggestion on how I should modify the code?
Thanks!
  댓글 수: 1
Walter Roberson
Walter Roberson 2021년 7월 21일
If you are certain that you will have a constant number of entries (201) for each time range, then it usually makes more sense to reshape() than to do the kind of looping you are doing.
I notice you are using a closed interval. If there happened to be any point that is exactly at one of the interval boundaries, then that point would be included in two different intervals, which would throw off the assumption of constant number of points per interval.

댓글을 달려면 로그인하십시오.

답변 (1개)

Jan
Jan 2021년 7월 20일
편집: Jan 2021년 7월 20일
Replace:
ts = -prePeak:1/fs:posPeak;
by
ts = linspace(prePeak, postPeak, 201);
But as far as I can see, you use ts only to measure its length. Then simply omit the definition and replace "length(ts)" by "201".
I'm not sure where the "201" is coming from, but I cannot know, why neural.spikes(S) has 201 elements.
  댓글 수: 5
Feng Du
Feng Du 2024년 2월 15일
Did you fix it? I meet the same question, I don't know how to fix it.
Voss
Voss 2024년 2월 15일
편집: Voss 2024년 2월 15일
@feng du: It's impossible to say how to fix this problem without seeing your code and data. I suggest you open a new question and share your code and data there.

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Logical에 대해 자세히 알아보기

제품

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by