Why is the output display not correct in Simulink?

Hello guys, I have some problems in Simulink with Fuzzy logic control.

As the picture shows below, with the two constant inputs, the output should be 0.92 as the Fuzzy rules show on the right.

But the display block on Simulink shows 0.5, so as the output scope. Why does this happened?

Please help me, thanks a lot!!

[Walter Roberson]

You test inputs [0.6;60] do not match your simulink constants 0.7041 with 541.6021

[kuan chan lai]

I see, thank you for answering me!!