Failed MATLAB install in linux, and now installer wont run properly
조회 수: 2 (최근 30일)
이전 댓글 표시
In Ubuntu 20.04 I was attempting to install R2019b. Interactively
Because I forgot sudo, eventually this file "AcquireGPSDataAndPlotYourLocationandSpeedonaMap.png" couldn't receive the rigth permissions and the installer couldn't continue. I could chmod the file and the folders but that didn't help. In fact the entire installations folder is 777.
Now when I restart the installer it just outputs this:
$sudo ./install
Preparing Installation files...
Installing...
Finished
I have also tried with an install of R2019a, and I have rebooted the machine too. Same results.
I have emptied /tmp...
It is like it remembers the condition that originally made it fail to install. But how do I clean condition to start over as root.
I have X11 working fine.
ONLY if I reinitiate the installer without sudo does it start fresh, but it ends the same place with the PNG file...
Should I not do this as root or how do I allow the PNG file(s) to install...?
댓글 수: 0
채택된 답변
Madhav Thakker
2021년 6월 29일
편집: Madhav Thakker
2021년 7월 1일
Hi Mads,
Please reach out to our Support Team. They would be able to assist you with installation and licensing issues.
Hope this helps.
댓글 수: 0
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Introduction to Installation and Licensing에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!