- Do not place a powergui block in the top-level diagram
- Place every independent model in a different subsystem
- Place a single powergui block in the top level diagram of every subsystem
Running powergui block in different simulation modes within the same model
조회 수: 2 (최근 30일)
이전 댓글 표시
MathWorks Support Team
2020년 10월 8일
편집: MathWorks Support Team
2022년 11월 23일
I want to run different parts of a model in different modes using powergui block. Different modes being discrete, continuous or phasor. Is it possible?
채택된 답변
MathWorks Support Team
2022년 11월 23일
편집: MathWorks Support Team
2022년 11월 23일
This is possible by dividing the photovoltaic(PV) system and the propulsion system as two subsystems. You can add two different powergui blocks (one in each subsystem) running in different modes. Important thing to keep in mind is that if you are using more than one powergui block in a model, then:
You can read more about this here: https://www.mathworks.com/help/sps/powersys/ref/powergui.html
댓글 수: 0
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Variable Initialization에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!