Finding tangent plane with the max range value and z value being equal

조회 수: 2 (최근 30일)
Rahal Rodrigo . 2021년 4월 16일
편집: Andrew Newell . 2021년 4월 16일
Hi there. I'm plotting a tangent plane to a particular surface. However, the range for both x and y if +- sqrt(2), which is +-1.41. The expected value of z for the tangent plane is sqrt(2) as well. However, when i run the command, MATLAB produces an error for that particulat range (produces sucessful output on ranges such as +-2). Would be grateful if someone provided insight what I could do to solve this issue. The code is shown below. Any advice would be greatly apreciated.

댓글을 달려면 로그인하십시오.

채택된 답변

Andrew Newell 2021년 4월 16일
편집: Andrew Newell 님. 2021년 4월 16일
Notice that j is empty, then try this:
X = -1.41:0.01:1.41;
[~,idx] = min(abs(X-1));
disp(X(idx)-1)
This being floating point, you're not getting exact increments of . You could scale everything so x, y are and then find and . Or you could do it like this:
z = @(x,y) sqrt(4-x.^2-y.^2);
X = -1.41:0.01:1.41;
[x,y] = meshgrid(X);
[~,j] = min(abs(X-1));
fx0 = fx(j,j);
fy0 = fy(j,j);
z1 = @(x,y) z(1,1) + fx0*(x-1) + fy0*(y-1);
As a side note, you don't need . You can use j directly as logical indexing.

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Programming에 대해 자세히 알아보기

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by