Connecting DC motor to a revolute joint

조회 수: 5(최근 30일)
Vicente Casanova
Vicente Casanova 2021년 3월 20일
답변: Vicente Casanova 2021년 11월 18일
I'm trying to interface the DC motor block (Simscape Electrical) to a revolute joint (Simscape Multibody). The aim is to develop a simulation model for a Pendubot.
Following several examples I think (I hope) I've made the connection properly, including the Rev-Rot interface to feedback the joint velocity into the DC motor but I have a doubt. If I want to change the friction, where is the right place to do it?. I've noticed that I can change the damping coefficient in the revolute joint (which is what I usually do) but it can be changed in the mechanical parameters of the DC block. (Rotor inertia).
Find attached a zip file with the simulink model and the stp files. Don't mind the commented blocks, just trying to model the motor non-linearity.
Thanks for your help.
Best regards

채택된 답변

Juan Sagarduy
Juan Sagarduy 2021년 3월 22일
Hi Vicente
It shall work in both cases, but it is more natural to do it on the Simscape side (DC actuator). This makes sense if u wanted to add friction later on.
Good luck Juan
  댓글 수: 2
Thi Pham Duy
Thi Pham Duy 2021년 11월 17일
편집: Thi Pham Duy 2021년 11월 17일
hello friend, if I want to add a coefficient of friction for the DC motor, how can I add it. I hope you can reply

댓글을 달려면 로그인하십시오.

추가 답변(1개)

Vicente Casanova
Vicente Casanova 2021년 11월 18일
I usually adde the friction in the damping coefficient of a revolute joint (Simscape Multibody) connected to the motor. But I'm not really sure if it is the right form to do it.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by