not getting how to plot output sensitivity using bode diagram in simulink

조회 수: 9 (최근 30일)
Aniket
Aniket 2013년 4월 1일
Hello i want to plot output sensitivity in simulink, how to plot it. right now i am using linearization points as we can seen in figure at output side and plat output side. and using bode block in simulink , this procedure right to plot sensitivity ?

이 질문에 답변하려면 로그인하십시오.

채택된 답변

Arkadiy Turevskiy
Arkadiy Turevskiy 2013년 4월 8일
Yes, that should give you 1/(1+P*C), where C is the transfer function corresponding to your inner loop.

추가 답변 (0개)

카테고리

Help Center 및 File Exchange에서 Simulink에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by