Hello, I was trying to generate code for TI DSP form the simulink model. It is a 3 phase pwm rectifier. But the code I generated doesn't look like that I can use for the DSP. My question is : # Do I need to make changes to my model in order to generate code? # Can I generate the required code for the DSP by only using Simulink or do I need to connect it to the real DSP board? # There is hardware implemetation in the parameter configuration dialogue and also a system preference block. Both of them can be used to chose a hardware. Which one should I use? Thank you so much.

generating code from embedded coder

Chenyang Zhang

2013 2월 15

0 답변

업데이트 시간: 2021 8월 20

조회 수: 1 (30일)

Follow Question

정보

이 질문은 마감되었습니다. 편집하거나 답변을 올리려면 질문을 다시 여십시오.

이전 댓글 표시

0 개 추천

Hello, I was trying to generate code for TI DSP form the simulink model. It is a 3 phase pwm rectifier. But the code I generated doesn't look like that I can use for the DSP. My question is :

Do I need to make changes to my model in order to generate code?
Can I generate the required code for the DSP by only using Simulink or do I need to connect it to the real DSP board?
There is hardware implemetation in the parameter configuration dialogue and also a system preference block. Both of them can be used to chose a hardware. Which one should I use?

Thank you so much.