Input in Simulink Test Manager are different from the actual input.

I was using Simulink Test Manager to test my model. I found that the input signals captured by Test Manager are not exacly the same as the original inputs, why is that?

The figure above is the actual input, and the figure below is the input captured by Test Manager. It looks like the actual input was move leftward by 0.05s. How to fix it?

[Sourabh Kondapaka]

Hi Jiabo Ren,

I have a couple of questions :

• Is "Signal Builder" being used within the test harness ?
• If yes, it is possible that the signal was defined to be offset by 0.05s to the left (could be by mistake)

[Jiabo Ren]

Hi Sourabh Kondapaka,

No, I don't use test harness at all. I created the signals by clicking 'create' in the input section of Test Manager and specified the model under test.