Simulink Dashboard Knob number of decimals

Is it possible to reduce the resolution (i.e. the number of decimals) of the knob?. I mean, when moving the knob it shoud stop (for example) in 4.2 or 4.3 but not in 4.23569871568....

Thanks

Answer 1

[Rohit Pappu]

The resolution of the knob can be adjusted using a block parameter called Tick Interval . Additional documatation about it can be found here

[Vicente Casanova]

Hi

Thanks for the answer. The thing is that I want the knob to stop olny at rounded values.

If I set the Tick interval at 10 (mminimum 0, maximum 100) and I move the knob it stops between two ticks and the value I get is (for example) 35.70614369710287. See attached image.

I don't want so many decimals. In this exaple I want the knob stops at 35.7 or 35.8.

Any ideas?

Thanks again.

[Rohit Pappu]

As of now, Simulink Knobs only take continuous values and their precision cannot be customized.

[Vicente Casanova]

Thanks again.

I would try to do it with the Round functión.

Best regards