Audiocapture objects error after connected to Raspberry Pi
조회 수: 4 (최근 30일)
이전 댓글 표시
Hi all, I am very new to using Matlab to interface with Raspberry Pi and I am trying to use its audio platform.
I have installed Matlab coder and the hardware supporting package.
But I am getting this error when I tried to run audiocapture:
audiocapture and audioplayer are supported only for code generation
I am runinng on Macbook and xcode is updated too.
Where should I look into for this problem? Any help is appreciated
댓글 수: 0
채택된 답변
Yihan Hu
2020년 10월 21일
댓글 수: 2
Jon Dana
2020년 10월 23일
편집: Jon Dana
2020년 10월 23일
I had the same issue and found that the following information is missing from the Raspberry Pi Audio tutorial:
- You need the Matlab Coder add-on
- You need to save the uncommented "raspi_pitchshiftdeployment()" function in a file
- Check available audio resources on the Pi with "system(rpi, 'aplay -l)"
Note:
- The demo was observed to stop after a few minutes. This is likely controlled by "for k = 1:3000"
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 MATLAB Support Package for Raspberry Pi Hardware에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!