MATLAB command line control of Simulink signal builder
조회 수: 1 (최근 30일)
이전 댓글 표시
Hi All,
I have a Simulink model that contains a signal builder that has 3 groups of signals. What I want to be able to do is simulate the model from a Matlab m-file for each group of signals. i.e. I will use the sim command 3 times to simulate the model 3 times, but before each time I use the sim command I need to be able to set the active group of signals in the signal builder. Is there any way to do this without have the model file open i.e. run the m-file but not open the .mdl file? Any help is greatly appreciated.
regards,
Andrew
댓글 수: 0
채택된 답변
Andreas Goser
2013년 1월 24일
I found an internal knowledgebase document about a similar question. You might need to contact technical support for more information referring to "solution 1-C3IKN1". It also says this is possible with R2012b and MathWorks can provide a woraround for older releases, but I am not too fmailiar with this matter and - again - suggest you contact technical support.
댓글 수: 1
추가 답변 (4개)
Albert Yam
2013년 1월 24일
Do you have to use a Signal builder? If you use a lookup table that references a variable 'mysignal' in the workspace, then redefine that 'mysignal' each time before running.
댓글 수: 0
Tonelli
2015년 5월 17일
Hi everybody, I can´t customize the name of the test cases of a signal builder created using a script. The "default name GROUPxx" is always taken as a reference. My goal would be to use a string digited by the user as a default name for the signal builder (i.e: test_case_A (from keyboard) --> Signal builder= test_case_A_1).
SBSystem = signalbuilder([ModelName,'/', SBName], 'create', [0 simulationTime], [0 0], char(ModelTLNameInport{1}), 'Test_COMPONENT_UNIT_Fctl_001');
(basically "Test_COMPONENT_UNIT_Fctl_001" must become the string given by the user).
Thanks a lot in advance. Regards
댓글 수: 0
참고 항목
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!