MATLAB Answers

the scope doesn't show the correct signal

조회 수: 1(최근 30일)
Cristian David Navarro Suárez
Cristian David Navarro Suárez 2020년 8월 27일
답변: Vasco Lenzi 2020년 8월 28일
i'm trying to simulate a simple AC circuit in simulink, i put a sinusoidal signal in a AC voltage source with 50V peak, and a resistance of 10 ohms in serie with the voltage source, that's all the circuit, when i measure the voltage using the scope it works and i see the correct waveform, but when i look for the current using the scope i don't see anything, (i am measuring the current in serie with the resistence and the voltage source)

채택된 답변

Vasco Lenzi
Vasco Lenzi 2020년 8월 28일
Hi Cristian
you modeled the circuit as open. Putting a voltage sensor there won't close the circuit to allow current to flow. So the result are correct. You need to properly close the circuit and place the sensor appropriately:
see this shipping example as well:
>>power_acvoltage

추가 답변(0개)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by