An error occurred while calling into the SIL or PIL target connectivity implementation.

Hello

I an trying to performe a Processor-In-Loop (Raspberry Pi) simulation for a simple model in Simulink.

I always get this error message (shown in attached picture):

An error occurred while calling into the SIL or PIL target connectivity implementation.

Caused by:

• Invalid Simulink object name: Subsystem
• The block diagram 'Subsystem' is not loaded.

I am not an expert, but here is my workflow :

1) From configuration parameters/solver set automatic solver selection.

2) From configuration parameters/hardware implemention set hardware board as Raspberry pi, and confirm the IP address, username, and password.

3) Form configuration parameters/code generation/interface check contineous time.

4) Form configuration parameters/code generation/verification/create block >> PIL.

5) Treat the subsystem as atomic.

6) Deploy the selected subsystem to hardware, copy the created PIL block to my model, then run the simulation.

Am I missing something?

[jindong zhao]

I have the same problem, did you solve it?

[Abdelrahman]

i have the same problem could u send he solution please

[Azizhan]

Any Update? I have to deploy this subsystem to the hardware in every openings.