How to update a signal in Simulink
조회 수: 8 (최근 30일)
이전 댓글 표시
I essentially need to do 'x = x + a*b' operation at every time-step in my simulation. The value of b is changing throughout the simulation and the value of x is given initially. I tried using 'memory' block for the same but wasn't able to get the desired result due to sample time mis-match. The values are getting updated every 0.2 seconds whereas the step-time is 1s.
Please suggest what blocks I should use; if possible a diagram too. I think I need a block which can act as a source but also have an option to be updated. Or any other way to carry out the above task would suffice.
I have done this in Matlab script and it was very easy there, but I need a Simulink model solution.
댓글 수: 0
채택된 답변
Fangjun Jiang
2020년 3월 30일
The true meaning of the equation is x=previous_x+a*b. Use the "Delay One Step" block (also called z-delay, unit delay, 1/z). The input is x, the output is previous_x, then construct your model.
댓글 수: 3
Fangjun Jiang
2020년 3월 31일
You can specify the initial value for the z-delay block. It "gets updated everytime" when the simulation is run.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Simulink Functions에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!