Getting waveform by using UART on Raspberry Pi and ADC on Ti F28335

조회 수: 2 (최근 30일)
Yue Ma
Yue Ma 2020년 3월 20일
편집: Pranav Murali 2020년 3월 27일
I am using Serial communication UART on Raspberry Pi to get waveform from ADC of Ti F28335 bacause there is no ADC on Raspberry Pi.
The results is shown below, in which, the middle one is correct waveform but the other two with spikes are wrong (they are supposed to be similar).
The ADC sampling frequency is from 1KHz-10KHz and UART is a bit larger than that.

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Pranav Murali
Pranav Murali 2020년 3월 27일
편집: Pranav Murali 2020년 3월 27일
I see that your waveforms from the ADC aren’t similar as they are supposed to. Since they sampling frequencies are different, If you are using Simulink, you will be needing a Rate Transition block which will ensure there is no loss or corruption of data. In MATLAB, make sure your sampling frequency is higher than the UART frequency.

카테고리

Help Center 및 File Exchange에서 Raspberry Pi Hardware에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by