Hi, Plese can you help me. I have USRP N210 with S/N: E4R22N6U, my software is Matlab R2016a and OS Windows. My question is: Can I use one USRP N210 (one device) as transmitter and receiver on the way that is RF1 is transmitter and RF2 is receiver ?
조회 수: 3 (최근 30일)
이전 댓글 표시
Hi,
Plese can you help me.
I have USRP N210, my software is Matlab R2016a and OS Windows.
My question is: Can I use one USRP N210 (one device) as transmitter and receiver on the way that is RF1 is transmitter and RF2 is receiver ?
Also, how to activate RF1 and RF2 ?
When I use some codes with VERT antenas I got the same results when I dont use Antenas.
With regards,
Ivana Ramljak
댓글 수: 1
Walter Roberson
2020년 1월 29일
I recently looked at a related question to this.
The N210 only has a single frequency synthesizer for both channels. Because of this you can only have one channel receive and the other transmit if the two are operating within a fairly narrow frequency range of each other. Apparently it is possible with the the hardware within that restriction.
With the two channels operating in such a narrow band you would need to implement echo cancelation. The driver for the N210 does not provide any algorithm for that.
답변 (1개)
Ivana Ramljak
2020년 1월 29일
댓글 수: 1
Walter Roberson
2020년 1월 29일
I have never used usrp so I do not know.
If you were to transmit the same signal you received, I would worry about echo cancelation, unless the transmission was after a notable delay.
참고 항목
카테고리
Help Center 및 File Exchange에서 Communications Toolbox에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!