how to add a new entry for legend while running a multiple plot

조회 수: 31 (최근 30일)
AKHILESH BARNWAL
AKHILESH BARNWAL 2020년 1월 21일
댓글: AKHILESH BARNWAL 2020년 1월 28일
% Timeseries Simulation
clear all;
clc
tic
x=1:10;
Sol=zeros(Nhr,6);
for i=1:3
y=i.*x;
figure (1), fig1 = plot(x,y);
legend(['plot for run ',num2str(i)])
hold on
end

답변 (1개)

Cameron B
Cameron B 2020년 1월 21일
x=1:10;
hold on
for ii=1:3
y=ii.*x;
fig1 = plot(x,y);
legvec{ii} = sprintf('plot for run %d',ii);
end
legend(legvec,'Location','northwest')
hold off
  댓글 수: 1
AKHILESH BARNWAL
AKHILESH BARNWAL 2020년 1월 28일
Thanks for the Answer.
This solution is quite good as I wanted, but there is no significance of this code as this code for legend entry does not recognize the plot of its own legend.,because all the legend entry are marked in same colour so it is difficult to identify the relevant plot with corresponding entry in legend. Please update me.
Thanks again for help.

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Legend에 대해 자세히 알아보기

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by