Using scatter3 in conjunction with setting axis limits draws at wrong coordinates
조회 수: 2 (최근 30일)
이전 댓글 표시
I try to plot a point at a specific 3d coordinate. But if I use set(gca, 'XLim' or 'YLim' or 'ZLim',...), the point is plotted at a wrong position in the 3D graph. Below, I put the code without set(gca ...) together with the plotted result. Then, I add code using set(gca ...) with the result.
close all
figure
p0 = [0 0 0];
p1 = [0 0 0];
plot3(p0,p1,p1)
grid
xlabel('x')
ylabel('y')
zlabel('z')
hold on
x = 1
y = 3
z = 9
scatter3(x,y,z)
%plot3(x,y,z,'*')
close all
figure
p0 = [0 0 0];
p1 = [0 0 0];
plot3(p0,p1,p1)
grid
xlabel('x')
ylabel('y')
zlabel('z')
lim = [0 10];
tick = (0:1:10);
set(gca,'XLim',lim)
set(gca,'XTick',tick)
set(gca,'YLim',lim)
set(gca,'YTick',tick)
set(gca,'ZLim',lim)
set(gca,'ZTick',tick)
hold on
x = 1
y = 3
z = 9
scatter3(x,y,z)
%plot3(x,y,z,'*')
Using plot3 instead of scatter gives the same results.
댓글 수: 0
채택된 답변
Navya Seelam
2019년 12월 6일
Hi,
The point is being plotted at right position. Try rotating the plot to make sure the point is at right position
댓글 수: 0
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Surface and Mesh Plots에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!