How to generate run to failure bearings data?
조회 수: 3 (최근 30일)
이전 댓글 표시
Hi. I want to do a predictive maintenance system with Matlab but I don't have enough bearings data. Do you know hot to generate run-to-failure data in Matlab ? I don't care about bearings type or parameters ?
댓글 수: 2
HF
2020년 12월 9일
Hello, did you find a generator or some bearing data. If yes, could you please share those?
Kind regards
답변 (1개)
Luke Halberstadt
2020년 12월 22일
A digital twin can enable you to generate additional bearing data with some knowledge of your bearings. For an introduction, please read the paper by Steve Miller on Predictive Maintenance using a Digital Twin:
To dive deeper, you can take a look at the eBook linked below which refers to additional resources. Since you have limited data, you are probably going for a physics-based or combined physics and data-based. For this, Simulink and Simscape can handle solver behavior and physics equations to help you produce failure data for thousands of component lifetimes
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Predictive Maintenance Toolbox에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!