I want to add this cell variable 'condition_col' to existing matrix 'data' if certain conditions are met, following code doesn't work, any help?
조회 수: 1 (최근 30일)
이전 댓글 표시
condition_col = 'codition1'
condition_col = cellstr(condition_col);
data = num2cell(data);
for i = 1:length(data)
if strcmpi(data(i,5),1) && data(i,6)> 5 && strcmpi(data(i,5), 2) && data(i,6) < 5
data{i} = [data, condition_col];
end
end
댓글 수: 3
Guillaume
2019년 8월 4일
following code doesn't work, any help
The code makes no sense at all and there's no comment explaining what it's meant to do.
Can you explain with examples using valid matlab syntax what it is you want to do?
채택된 답변
newbie9
2019년 8월 4일
See if this helps to get you on the right track:
% set up dummy data to work with
data = rand(20,1);
data = array2table(data);
data.Properties.VariableNames = {'MyColumnName'};
for ii = 1 : height(data)
% example condition, use your condition instead
if data.MyColumnName(ii) < 0.5
data.codition1{ii} = 'Condition Met';
else
data.codition1{ii} = '';
end
end
댓글 수: 4
newbie9
2019년 8월 5일
Thanks Guillaume, that is a much better approach. Maybe you should write it up as a separate answer so the OP can accept it as the correct answer.
Guillaume
2019년 8월 5일
I'm fine with you getting the credit. You understood what the OP was asking for and got him in the right direction.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Logical에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!