How can I comment out an outport in Simulink model?
조회 수: 23 (최근 30일)
이전 댓글 표시
I have the case where a subsystem of my model can be commented out. In that case, the outports connected to the outputs of that subsystems will give a zero when the simulation is run. In my case, I don't want anything at all, since afterwards I'm checking if a given signal exists or not, and since a 0 was given, the signal seems to exist, but it should not.
If I simply use Ctrl+Shift+X (Comment Out) on the outport, I get the warning dialog "Commenting out of the following block(s) is not supported: my_model/my_outport".
Running on Matlab 2017b.
댓글 수: 0
채택된 답변
Alex Burbee
2019년 7월 30일
In my exerience, you can deleate the out port or simply use a termination block where it comes out.
Hope it helps
댓글 수: 0
추가 답변 (1개)
Marcelo Moraes
2022년 1월 11일
Indeed it is not supported, but it's very frustrating.
It's like trying to add a // in the begining of a C code line and being forced to delete it before compilation.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Sources에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!