Changing the X axis in Simulink Scope
조회 수: 11 (최근 30일)
이전 댓글 표시
i'm simulating a rectifier and want to know if I can change the X axis from time (0 , 0.02) to (0 , 2pi )
this what i want , check the x axis
thanks
댓글 수: 0
답변 (1개)
Sabin
2023년 3월 13일
Simulink Scope will normally display data until simulation end time (starting from beginning or displaying only last N values). After simulation stops you can plot and process data as needed. If you want to display data only until 2*pi then the very simple solution would be to use 2*pi as Stop Time.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 View and Analyze Simulation Results에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!