Adaptive MPC controller, Oscillatory overshooting before starts tracking, need to know how to settle the overshoot, please.
조회 수: 1 (최근 30일)
이전 댓글 표시
Hi,
Am desiging an adaptive MPC contoller for a non linear plant using online model estimation, the objective is to control the rolling speed of hot rolling steel mill. I have done all the design procedures and connected all related blocks, simualtion was successful but when it comes to the result am having an oscillatory overshooting before the output starts to track the reference signal. Any advice on the reasons?
댓글 수: 0
답변 (1개)
Siriniharika Katukam
2019년 8월 7일
Hi
If system does not have complex poles, then there is no chance for oscillatory overshoots. So, make sure that your system design does not lead to complex poles.
This link might be helpful for you to understand in limiting the overshoot :
참고 항목
카테고리
Help Center 및 File Exchange에서 Linear Plant Specification에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!