Arduino external mode scope simulink
조회 수: 1 (최근 30일)
이전 댓글 표시
Hi, I have an Arduino Uno and I send a PWM on PIN 10 and I want to measure its Ton time.
The PIN 10 is linked with PIN 5, and it is plotted on simulink scope.
This signal is manipuleted with a Discrete-Time Integrator, so its maximum value of every sawtooth is the desidered value (Ton).
I have the following problems:
-the scope doesn't read well the PWM;
-the Discrete-Time Integrator doesn't send out the correct value.
What are the problems?
P.S. I) My sampling time of simulation is 1e-5.
P.S. II) My solver is ode8
P.S. III) I have measured the PWM on oscilloscope, and It read very well the signal.
Thank You. I attach my scheme and the arduino.
Best Reguards
댓글 수: 0
답변 (2개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Arduino Hardware에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!