Simulink model for DC shunt motor does not give correct output despite no errors.

조회 수: 2 (최근 30일)
Saiankita Anand
Saiankita Anand 2018년 10월 14일
답변: Sabin 2024년 12월 24일
The attached Simulink .mdl file (MATLAB 2017) contains a model for DC shunt motor. The DC motor block was cut and pasted from MATLAB 2014. The model runs but the output is not correct. Scope does not show plots for armature current vs speed, torque vs speed.
Help and suggestions appreciated.

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Sabin
Sabin 2024년 12월 24일
This seems to be a parameterization issue. Increasing the field resistance to 150 Ohm will enable simulation to a nonzero speed. The exact parameterization will depend on application requirements.

커뮤니티

더 많은 답변 보기:  Power Electronics Community

카테고리

Help Center 및 File Exchange에서 Motor Drives에 대해 자세히 알아보기

태그

제품

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by