I have modeled 'Battery controlled DC motor using DC-DC converter (Bidirectional)' in simulink. Voltage keeps increasing?Why?Also, high discharge current.

조회 수: 3 (최근 30일)
Praveen Kumar
Praveen Kumar 2018년 10월 3일
답변: vinod 2023년 10월 6일
I have modelled battery controlled DC motor using a DC-DC converter with closed loop PI controller. When I am using a simple resistor as load it is working fine and able to maintain a voltage at 48V. But, when I use DC motor with similar parameters, voltage keep increasing. Even though armature current is around 20A, the battery is discharging at ~200A in this case. I have attached the model. Much appreciated if anyone can spot the mistake or give a solution.

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

vinod
vinod 2023년 10월 6일

커뮤니티

더 많은 답변 보기:  Power Electronics Community

카테고리

Help Center 및 File Exchange에서 Electromechanical에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by