I get the following message when I run my rtl sdr model

조회 수: 23 (최근 30일)
Derek Eccles
Derek Eccles 2018년 9월 17일
댓글: 2023년 11월 8일
An error occurred while running the simulation and the simulation was terminated Caused by: An error occurred in the driver library. You can look up the full error message in MATLAB by executing message('ID','Message'): ID : sdrr:driver:LostConnectionSL Message: 0

답변 (1개)

Ethem
Ethem 2019년 3월 20일
>> message('sdrr:driver:LostConnectionSL','0').getString
ans =
'Lost connection to radio 0. Connect radio to computer and run model again.'
This may happen if you unintentionally unplugged the radio.
  댓글 수: 3
Ethem
Ethem 2021년 1월 27일
This message is generated when the computer looses connection to the radio. If your radio looks like it is still attached to the computer, you can try to unplug and replug it. If the problem repeats, try using another USB port. If the problem persists, you may have a defective radio.
行
2023년 11월 8일
Changed the USB interface, still error. How do you handle it?

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Analog Devices ADALM1000 Support from Data Acquisition Toolbox에 대해 자세히 알아보기

제품


릴리스

R2016a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by