How should I set VREFHI in ADC in moicrocontroller of F28069M inside simulink\matlab and also In the form of hardware?

조회 수: 4 (최근 30일)
mohammad farahani
mohammad farahani 2018년 6월 23일
편집: mohammad farahani 2018년 6월 23일
Hello I use LAUNCHXL-F28069M. In model configuration, VREFHI has been set 3.3 volt inside simulink/matlab. and micro VREFHI pin has also been connected to launchpad 3.3 volt pin. But I recieve 3 volt as maximum volt on analog pin( which means that micro ADC gives 0 to 3 volts for 4096 digitdal level. What's the reason? On the other side, how could I set VREF externally?

이 질문에 답변하려면 로그인하십시오.

답변 (0개)

카테고리

Help Center 및 File Exchange에서 Instrument Control Toolbox Supported Hardware에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by