why matlab hangs up when i use 2 channels from analog discovery with data aquisition toolbox
조회 수: 1 (최근 30일)
이전 댓글 표시
clear
s = daq.createSession('digilent')
ch = addAnalogOutputChannel(s,'AD1', 1:2, 'Voltage')
rate = 1e6;
s.Rate = rate;
outputData(:,1) = linspace(-1,1,1000);
outputData(:,2) = linspace(-2,2,1000)';
queueOutputData(s,outputData);
startForeground(s);
hi,
i whant to generate signals on two channels with analog discovery divice, with data aqisition toolbox. While using one channel there are no problems occuring. When i use two channels (with the code below) the signals gets generated, but then matlab dont stops running and i can unly quit when closing matlab.
I am very grateful for help
댓글 수: 0
답변 (1개)
Sai Deepesh Pokala
2018년 6월 8일
When you install MATLAB, there is a cap on the RAM that it is allowed to occupy. Therefore, if your code involves creating temporary high-dimensional arrays or matrices, chances are it might reach that limit. Try eliminating unwanted loops or assignments. Good luck!
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Data Acquisition Toolbox Supported Hardware에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!