Info

이 질문은 마감되었습니다. 편집하거나 답변을 올리려면 질문을 다시 여십시오.

How can I change the block substitution to match the dimensions of the block in the Simulink model

조회 수: 2 (최근 30일)
sujit bhuyan
sujit bhuyan 2018년 5월 26일
마감: Sabin 2023년 9월 27일
In "linearize(modelname,io)" using block substitution the input-output dimensions of the substituted block linearizations the input-output dimensions of the block being replaced. The block substitution for pv_hybrid_phd_model/3-Phase Dynamic Load/Model/Discrete/Unit Delay2 has dimensions [1 x 1] and the Simulink block has dimensions [2 X 2]. Change the block substitution to match the dimensions of the block in the Simulink model.
  댓글 수: 1
utsav sharma
utsav sharma 2019년 5월 12일
Why no answer on this question? I am facing the same difficulty using the control system tuner for PMSM drive. Simple PI controller is not getting tuned by control system tuner and this same messgae is flashing over and over. Kinldy help on this issue.

이 질문은 마감되었습니다.

답변 (0개)

이 질문은 마감되었습니다.

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by