how to swap input interfaces with each other without using switch or if block?

조회 수: 3 (최근 30일)
Amit
Amit 2018년 4월 4일
답변: Birdman 2018년 4월 4일
eg. I have four input interfaces H1,H2,H3 & H4. So based on some valid condition i have to swap these signals like this (H4->H1,H3->H2,H2->H3,H1->H4). I had implemented this using switch block but since i have so many interfaces, it is creating mess in the code as well as design also. Is there any alternative way to implement optimized design for this? Implemented image is attached.

이 질문에 답변하려면 로그인하십시오.

채택된 답변

Birdman
Birdman 2018년 4월 4일
Use a MATLAB Function block. You will be writing if else if or switch statements as if you were writing it on MATLAB command line.

추가 답변 (0개)

카테고리

Help Center 및 File Exchange에서 Simulink Functions에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by