필터 지우기
필터 지우기

slicing 3D stl file to 2D series of image

조회 수: 24 (최근 30일)
sareh
sareh 2012년 5월 21일
댓글: MUHAMMAD HUSNAIN 2024년 3월 29일
Dear all,
I have a 3D model in the format of .stl and I would like to slice it in z direction into cross sections with format of image(any format), I have searched alot to use different softwares but it is not useful in my case,I appreciate any idea Regards Saréh
  댓글 수: 4
Karoline Neumann
Karoline Neumann 2017년 8월 18일
I need a similar thing. Only I'm not interested in the image, but the cross section areas.
MUHAMMAD HUSNAIN
MUHAMMAD HUSNAIN 2024년 3월 29일
Hello,
I also have similar problem as Sareh(@sareh), I want to print slices of a 3D model in inkjet printer but to print that I need that sliced files in any Image format (e.g PNG, GPEG etc). Is there any software or any procedure that I can use to get this. Any help pls.
Regards Husnain

댓글을 달려면 로그인하십시오.

답변 (4개)

Dang Le Van
Dang Le Van 2016년 7월 6일
You can use SLICE command in Netfabb software!

Sleh Eddine Brika
Sleh Eddine Brika 2016년 11월 1일

Sailesh Sidhwani
Sailesh Sidhwani 2019년 10월 19일
편집: Sailesh Sidhwani 2019년 10월 19일
Check out these new viewers that are added to Image Processing Toolbox in R2019b:

Qinkai Yang
Qinkai Yang 2022년 10월 8일
you may need to look at plane-line intersection algorism. The inersection points between each triangle's edge and a slice plane are the data point of your sliced corss-section. Changing the Z-cordinate of your slice plane, repeat the intersection, you would then get a series of slices (2D series of image)

카테고리

Help CenterFile Exchange에서 Read and Write Image Data from Files에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by