J1939 Communication over CAN -Vehicle Network Toolbox

조회 수: 9 (최근 30일)
ilker ozturk
ilker ozturk 2018년 2월 14일
편집: ilker ozturk 2018년 3월 16일
Dear Users and Matlab team,
I am trying to read can singnals of bms function using vehicle network toolbox. I have a dbc file which describes can signals of bms. But when I open the dbc file using J1939 Configration blok, Matlab said that Network Configration might not be valid J1939 File. But I am sure that dbc file was produced under J1939 standarts. Do you know any way to test dbc file for checking standarts, using Matlab? Could you help me about this issue?
Best Regards

이 질문에 답변하려면 로그인하십시오.

채택된 답변

ilker ozturk
ilker ozturk 2018년 3월 16일
편집: ilker ozturk 2018년 3월 16일
Dear All,
Solution is basic, add DbBusName,BusType and ProtocolType to the Attributes section in your dbc file, Matlab accepts this solution with J1939 Communication Blocks.
Best Regards

추가 답변 (0개)

카테고리

Help Center 및 File Exchange에서 Vehicle Network Toolbox에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by