I am trying to use matlab support package for raspberry pi to control a motor board
조회 수: 2 (최근 30일)
이전 댓글 표시
I am trying to control a motor card using Raspberry Pi support package. Has anyone done this before? I am using the mdd10a control board which requires a PWM signal as well as a left vs right boolean signal. Any help would be appreciated.
댓글 수: 0
답변 (1개)
Shashank
2018년 2월 15일
Hi Shima,
To do this, you can use 2 GPIO pins on the raspberry pi. Please refer to the following link for the overall workflow:
2. Write Duty cycle and frequency to that pin. Refer to the example here:
Hope this helps
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Raspberry Pi Hardware에 대해 자세히 알아보기
제품
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!