How to simulate real MOSFET in simulink ?

조회 수: 25 (최근 30일)
Henry Buck
Henry Buck 2018년 1월 16일
댓글: Necip Baha Bagriacik 2024년 4월 2일 8:31
Hi there, While I'm using MOSFET component from simulink, it has its own parameters as attached (Mosfet parameters.jpg).
Concidering data sheet(attached too - datasheet MOSFET.pdf) there is a lot of information on it. I want to use real parameters in simulink to show simulation result losses.
Is any one knows how to do it ?
Thanks, Henry

답변 (1개)

Sabin
Sabin 2024년 1월 22일
Probably best to use the N-Channel MOSFET in Simscape Electrical if you want to simulate the nonlinearities. This block has a higher fidelity.
  댓글 수: 1
Necip Baha Bagriacik
Necip Baha Bagriacik 2024년 4월 2일 8:31
I want to simulate Three phase totem pole PFC active rectifier high fidelity and realistic.I use this MOSFET but i want to enter the parameter from datasheet. Which mosfet model is the most suitable for me?
Thanks a lot, Necip Baha

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Semiconductors and Converters에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by