shouldn't the reference frame replace the frames of the subsystem
조회 수: 5 (최근 30일)
이전 댓글 표시
Hi I am building a robot arm simulation
and I built every joint out of cylinders then made it a subsystem.
the frames is not where they should be so I am added a reference frame to the subsystem
but when I Specify Position in the State Targets in the Z Reveloute Primitive (Rz) it still use one the 2 solids' frames and this is what I end up getting.
bold where its obviously rotating around the axis shown in the picture (above) which is one of the solids' Axis (solid 9) and not the reference frame . can someone tell me what am I doing wrong??? Thank you very much
댓글 수: 0
답변 (1개)
Qu Cao
2017년 10월 17일
Since the Reference Frame is attached to Solid 8 not the World Coordinate, the rotating axis will be one of the Solids 8's references frame.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Robotics에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!