How do I run a load flow analysis for a solar PV array?
조회 수: 4 (최근 30일)
이전 댓글 표시
I simulated a microgrid on matlab simulink. I want to run a load flow analysis of the system. However matlab does not recognize the solar PV array in the microgrid as a source. When I place a load flow bus after the inverter of the PV array, it produces an error message saying the model does not converge. Increasing the number of iterations does not help. Any advice would be greatly appreciated
댓글 수: 2
Mateus Franco
2019년 1월 22일
Hello I have the same doubt, did you find the solution? Thanks for helping.
답변 (2개)
Shafiq Aidil
2019년 11월 12일
you can find it in simscape electrical library. just install add ons simscape and simscape electrial then you can find pv array in the library.
library>simscape>specelized power systems>renewable>solar![689463bc-5fea-44dc-a835-b8933bc1c24a.jfif](https://www.mathworks.com/matlabcentral/answers/uploaded_files/247859/689463bc-5fea-44dc-a835-b8933bc1c24a.jpeg)
![689463bc-5fea-44dc-a835-b8933bc1c24a.jfif](https://www.mathworks.com/matlabcentral/answers/uploaded_files/247859/689463bc-5fea-44dc-a835-b8933bc1c24a.jpeg)
댓글 수: 0
Joel Van Sickel
2020년 9월 2일
Hello Rusith,
the inverter is not supported for load flow, here are the supported blocks:
Regards,
Joel
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Electrical Sensors에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!