How to use Simscape Mutlibody in accelerator Mode?
조회 수: 4 (최근 30일)
이전 댓글 표시
Hi Guys. I have a bit complicated model combines between simulink and simscape multibody. In the simulink I have many zero crossing because I am using PWM generation, and usually it has zero crossing. So, I am using Accelerator Mode. When I get to combine both models, I receive an error that multibody doesn't support accelecrator mode, and I have to turn visualisation off!!! Could you please give me more explanation about this problem and how to sort it out? Regards.
댓글 수: 0
답변 (1개)
Brandon Eidson
2017년 9월 11일
Hey Karem, I think what you are experiencing is expected behavior. Simscape Multibody visualization using the Mechanics Explorer is only supported in the "Normal" simulation mode. As mentioned in the documentation linked-to below, there are other circumstances in which visualization is not supported.
If you have a model that simulates fine in normal mode, but the simulation does not run in accelerator mode, I suggest creating a new case with MathWorks Technical Support. Please provide them with the exact error message you are receiving and all files steps necessary to reproduce the error.
댓글 수: 2
참고 항목
카테고리
Help Center 및 File Exchange에서 Simscape Multibody에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!