How can I get rid of the horizontal white lines?

조회 수: 18 (최근 30일)
Tiffany Mao
Tiffany Mao 2017년 7월 13일
댓글: Image Analyst 2017년 7월 25일
How can I remove the horizontal white lines from an image like these without majorly editing the surroundings? Medfilt has been suggested, but it doesn't seem to be working. All code is appreciated. Thank you!

답변 (3개)

Image Analyst
Image Analyst 2017년 7월 13일
You can try Fourier filtering. The white lines, if they're periodic, will show up as spikes in the spectrum which you can then zero out and inverse transform. Example attached (with demo image, not yours).
  댓글 수: 4
Tiffany Mao
Tiffany Mao 2017년 7월 14일
I edited the code to get ride of the first part and changed the subplots, but the result is like this?
Image Analyst
Image Analyst 2017년 7월 14일
편집: Image Analyst 2017년 7월 14일
It doesn't look like thresholding is a good way to get the spikes. You might try zeroing out the very small, exact area where you see spikes on the Y axis of the spectrum, if you can see them. Otherwise you'll have to try some kind of ad hoc filter in the spatial domain, like summing your image horizontally (to get the vertical profile)
verticalProfile = mean(grayImage, 2);
and looking for peaks/spikes in the vertical profile..

댓글을 달려면 로그인하십시오.


Eric
Eric 2017년 7월 14일
K-Nearest Neighbor Filtering does a decent job. You can play with the parameters, but here are some quick settings I tried.
For each pixel, find the 49 nearest neighbors. Of those 49, average the 25 pixels nearest in intensity to the selected pixel. Replace the value of the selected pixel with that mean.
This can be done fairly efficiently with colfilt(). The result isn't perfect, but it's not terrible, either. I attached the result for enf.jpg.
Good luck,
Eric
  댓글 수: 1
Eric
Eric 2017년 7월 14일
You could also try the median of the 25 pixels nearest in intensity to the selected pixel.
Neighborhood operations like this should help. The lines are 1D so looking at statistics over small, 2D regions will help beat down the noise associated with the 1D streaks.

댓글을 달려면 로그인하십시오.


Image Analyst
Image Analyst 2017년 7월 15일
You can get the vertical profile, find the peaks and then replace those lines with the median filtered version. See attached test.m file.
Not perfect, but a fairly good improvement. Spend a day tweaking it and you might even get it better.
  댓글 수: 7
Image Analyst
Image Analyst 2017년 7월 24일
The peaks are calculated by taking the mean across the image to get the vertical profile. Then it finds the lower boundary of that profile and subtracts that smoother curve. Any peaks will have a higher value than lines without peaks and be detected by a thresholding. Any line above the threshold is determined to be a bad line with peaks and is replaced by the median filtered line.
Other lines are not affected, only lines with peaks are affected.
Why not put some energy towards making sure the noise lines don't appear in the first place. It's often easier to prevent the problem than to fix it once it's there.
Image Analyst
Image Analyst 2017년 7월 25일
Have you checked PubMed, or the Image Processing Literature for papers related to breathing and heartbeat correction?

댓글을 달려면 로그인하십시오.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by