How to use arduido with stepper motor and HY-DIV268N-5A driver
조회 수: 1 (최근 30일)
이전 댓글 표시
Hi
Hope someone can help me on this please.
What do I have: Stepper Motor Wantai WT57STH115-4204A with 4.2A(U) and 1.8deg/step --> 200 steps Driver HY-DIV268N-5A Arduino Mega2560
Step motor is connected with the driver The driver is connected to a power suply and to arduino. In the driver the Dir- is conected to the Pul-
Connection between driver and arduino is:
Dir+ connected to arduino port 8 Pul+ connected to arduino port 9 Pul- connected to arduino port 11
This e all very new for me and need to be able to create a guid to control de step motor. But I have no clue how to perform this even after see some videos (most of them using Adafruit which I dont use) and read some documentation. Any help would be apreciate.
Can some one please juste showm me the basics to start the step motor rotation and define the velocity?
At the end the goal would be to control 5 step motors wit arduino.
댓글 수: 0
답변 (1개)
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Arduino Hardware에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!